|This is the end of the run.|
|I drilled small holes in the top of the wire molding to pass 2 wires for each jack.|
|Ran wire molding above door frames in hallway, and down wall|
at end of hallway.
The wire you see sticking out going thru the door was an existing cable wire
that the customer had in place before I got there, I just pushed it into our molding.
|Nothing left to waste. |
In the boiler room I used scrap pieces to secure the wires to the wall.
|Even the power is run through the wire molding.|
|Aris Cable modem (left)|
8 port TP-Link switch (middle top)
12-port Patch panel (middle bottom)
Linksys/Cisco E1200 router (left)