Customer had already installed the wiring to the door.
Door phone and keypad mounting brackets installed.
Door phone installed, wiring keypad.
Wiring the keypad.
Door phone and keypad installed (opps! the bracket for the keypad is upside down)
The reason the bracket was initially installed upside down is because
the hole for the wire is on the bottom of the mount, not the top.
RC2A relay installed for door release via phone.
Wiring everything up to the relays, dial tone and power supply.
RC2A mounted and wired.
Everything is done - keypad mount now mounted properly.
Hopefully the wire does not get damaged, since the hole for the
wire is located at the bottom of the mount, and the wire is
run behind the bracket to the hole on the surface of the brick.
Not shown is the Linksys PAP2 that was installed to connect dial tone to the E20B door phone and RC2A relay.
THIS DIAGRAM NEEDS TO BE MODIFIED IT IS NOT COMPLETELY ACCURATE:
Here is a diagram that I put together that is close to how it is wired (all splices are actually done at the RC2A as you can see in photo above) **upon review of the above image, the solid green wire is going to the door strike not the striped green)***